Tunze Osmolator 3155

The TUNZE Osmolator® 3155 is used to ensure osmotic stability in freshwater and marine aquariums. It guarantees exact and effective compensation of evaporated water. This water level regulator. It contains a Controller, two sensors, two Magnet Holders for sensors and a wide range of accessory elements.

Suitable for placement in filtration installations in a modular cabinet located below, in the Comline filter or directly on the edge of the aquarium. The Magnet Holder for two sensors is suitable for a glass thickness of up to 15mm, the Magnet Holder for the safety sensor is suitable for a glass thickness of up to 12mm. Available at www.cetamar.com.

Two sensors are used in this filler, that is, a working sensor to control the water level and a safety sensor against overfilling of the aquarium. The working sensor monitors the water surface and activates the Controller when it falls below the set water level. The Controller connects the dosing pump that transports water from the reserve tank to the aquarium until the volume of evaporated water has been restored. The controller with electronic time control then automatically switches off the dosing pump. If, for technical reasons, the working sensor fails, the safety sensor will prevent overfilling of the aquarium and will emit an acoustic signal. If the dosing pump runs for more than 10 minutes, it will shut down for safety.